Blog

blog

How to Create Your Own Dog Mask – The Basics

In this report we’re going to look at how to create your own dog mask. We’ll cover the basics and then go on to look at some of the more advanced tips and tricks that you can use.

If you have a dog that likes to bark, and especially if your dog loves to play in the backyard and other areas of the house, you will need to get them some special dog protection.

Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the set-up which will look a little scary at first, but it is really very straightforward. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can’t just cut a rectangular shape out of the cardboard, so you’ll have to cut around the edge of the mask so you get something which resembles a cone. The most important thing here is to be realistic with what kind of paper plate which you’re using.

Then you’ll have to wrap the cardboard around the edges of the paper plate, making sure that there is a good seal between the two pieces https://ehlelmotivation.com/?p=62125 so that you can make certain that nothing will leak when you place the mask on. Be sure that the edges are cut so that the edges aren’t sharp, as this may damage the edges of the mask.

Glue it on! The next step involves using some paint. You ought to spray the paint over the cardboard, making certain it runs smoothly and evenly across the entire mask. You will want to start with one side of the mask , so you can work your way around it before moving onto the other side. The paint needs to be slightly thicker than the cardboard, and it’s best that you leave about one-fifth of an inch of paint on the edges so that it runs over the cardboard.

Don’t fret too much about the paint getting stuck to your mask. It’s easy to eliminate it later, and it will leave you with a wonderful finished mask to show off to everyone! It’s also a good idea to wipe away any excess paint after you are done, so that you don’t wind up with smudges or smears on your dog.

Then it is time to paste the mask onto your dog’s head. First you will need to make sure that you have a secure fit between the mask and your dog’s head. Once you’ve made sure that it’s secure, then you may begin to glue the mask onto the dog’s face. Take the piece of cardboard that’s used for the base of the mask and then fold it over. Make sure that it’s quite strong and then use your hands to secure the cardboard down in place.

Keep your hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds until you have the mask snugged firmly onto the face of your dog. Don’t make the folds too large or else it might look messy. Once you’ve completed this, you can then take out the mask and attach the cardboard ears. And attach the other part of the mask on the dog. Make certain that the ears are level and be certain it’s not too short or long as this will cause some issues with the mask slipping off the dog’s face.

If you are using a dog mask as your dog protection, you will have to do some sanding to be sure that it’s secure on your dog. You can do it by sanding off any excess paper which might have been removed from your mask.

Leave a Reply

Scroll to top